If there are 2 or more ports with the same priority then port with the smallest port number will have a higher priority. Highest priority is 0, the lowest priority is 99. Poe-priority specifies the importance of PoE-Out ports, in cases when a total PoE-Out limit is reached, interface with the lowest port priority will be powered off first. Poe-priority ( integer:0.99 | any Default: 10) off - all detection and power is turned off for this port.As a result power over Ethernet will be always on forced-on - detection range is removed.For powering there should be resistance in the range from 3kΩ to 26.5kΩ auto-on - the board will attempt to detect if power can be applied to the port.Poe-out ( auto-on | forced-on | off Default: auto-on) RouterOS provides an option to configure PoE-Out over Winbox, Webfig, and CLI, basic commands using the CLI are PoE Configuration is supported on all MikroTik devices with PoE-Out interfaces, the configurations can be edited from the RouterOS and SwOS interfaces. CRS112-8P-4S-IN, CRS328-24P-4S+RM, CRS354-48P-4S+2Q+RM.)Įach PoE-Out implementation supports overload and short-circuits detection. MikroTik devices that support af/at standard can also switch to Passive PoE-Out mode. Valid PD should have PoE-In resistance from 23.75kΩ to 26.25kΩ. MikroTik PSE with af/at support is capable of powering both a Type 1 and a Type 2 PD. The aim of these standards is to reduce incompatibility between vendors. IEEE Standards 802.3af/at - Also called PoE Type 1/PoE+ Type 2, are PoE standards Defined by the IEEE. PD resistance should have ranged from 3kΩ to 26.5kΩ. Can power up af/at compatible devices, which accepts power over 4,5 (+) and 7,8 (-), and does not require PoE negotiation. The output voltage depends on the power source connected to PSE.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |